Classes | |
class | mio::EditingSwap |
SWAP input editing command. More... | |
class | mio::EditingRename |
RENAME input editing command. More... | |
class | mio::EditingExclude |
EXCLUDE input editing command. More... | |
class | mio::EditingKeep |
KEEP input editing command. More... | |
class | mio::EditingMerge |
MERGE input editing command. More... | |
class | mio::EditingAutoMerge |
AUTOMERGE input editing command. More... | |
class | mio::EditingCopy |
COPY input editing command. More... | |
class | mio::EditingCreate |
CREATE input editing command. More... | |
class | mio::EditingMetadata |
METADATA input editing command. More... | |
class | mio::EditingRegFill |
RegFill input editing command. More... | |
class | mio::FilterDeGrass |
This filter is used to distinguish if snow (HS) is on the ground or not. More... | |
class | mio::FilterDespikingPS |
Despiking filter using phase space. More... | |
class | mio::FilterKalman |
A statistical filter for state likelihood estimation: the Kalman filter. More... | |
class | mio::FilterMAD |
Median Absolute Deviation. More... | |
class | mio::FilterMaths |
A filter that evaluates formulas dependent on conditions. More... | |
class | mio::FilterMax |
Max range filter. More... | |
class | mio::FilterMin |
Min range filter. More... | |
class | mio::FilterMinMax |
Min/Max range filter. More... | |
class | mio::FilterMinMaxConditional |
Applies a min/max filter if a second parameter matches a comparison. More... | |
class | mio::FilterNoChange |
This filter removes periods showing insufficient changes. More... | |
class | mio::FilterParticle |
A Monte Carlo sampling method: the particle filter. More... | |
class | mio::FilterPotentialSW |
Checks for physically realistic incoming short wave radiation (ISWR) values. More... | |
class | mio::FilterRate |
Rate of change filter. More... | |
class | mio::FilterStdDev |
Standard deviation filter. More... | |
class | mio::FilterSuppr |
Suppression filter. More... | |
class | mio::FilterTimeconsistency |
Check that the time evolution of a given parameter is consistent with its past evolution. More... | |
class | mio::FilterTukey |
Tukey 53H method. More... | |
class | mio::FilterUnheatedPSUM |
Filters out snow melting in an unheated rain gauge. More... | |
class | mio::ProcAdd |
Add an offset to the values. More... | |
class | mio::ProcAggregate |
Data aggregation. More... | |
class | mio::ProcDeAccumulate |
Convert accumulated values back to instantaneous values. More... | |
class | mio::ProcExpSmoothing |
Exponential smoothing. More... | |
class | mio::ProcIIR |
Infinite Impulse Response (IIR) filter. More... | |
class | mio::ProcMult |
Multiply values. More... | |
class | mio::ProcPSUMDistribute |
Distributes precipitation on the preceeding timesteps in a physically plausible way. More... | |
class | mio::ProcQuantileMapping |
Quantile Mapping correction. More... | |
class | mio::ProcReducePressure |
Convert local pressure to sea level pressure. More... | |
class | mio::ProcRHWaterToIce |
Correct relative humidity over water to over ice in case temperature is below freezing. More... | |
class | mio::ProcShade |
Apply a shading mask to the Incoming or Reflected Short Wave Radiation. More... | |
class | mio::ProcShift |
Time shifting filter for the selected meteo parameter. More... | |
class | mio::ProcTransformWindVector |
This filter reprojects wind direction, and/or wind speed components, between PROJ supported coordinate systems. More... | |
class | mio::ProcUndercatch_Forland |
Correct precipitation for undercatch in winter conditions. More... | |
class | mio::ProcUndercatch_Hamon |
Correct precipitation for undercatch in winter conditions. More... | |
class | mio::ProcUndercatch_WMO |
Correct precipitation for undercatch in winter conditions. More... | |
class | mio::ProcUnventilatedT |
Filters and corrects temperatures from unventilated sensor. More... | |
class | mio::ProcWMASmoothing |
Weighted moving average smoothing. More... | |
class | mio::TimeSuppr |
Timesteps suppression filter. More... | |
class | mio::TimeShift |
Time corrections. More... | |
class | mio::TimeSort |
Sort out of order timesteps. More... | |
class | mio::TimeLoop |
Loops over a specific time period. More... | |
Documentation for available data processing components. These can be used on incoming meteorological data. See Available data processing elements.